SCADA Runtime Connectivity

[pauloodwazny]

Hello.
I have a problem with my Zeon Logic, my external visible variables are visible in the Zenon Logic,

but the values are not visible.

This means that, if I change the value of the tag in Zenon SCADA, there is no change in the Zenon Logic.

The same if I change the values in Zenon Logic, there is no change in Zenon SCADA.

I created the Logic project so as the image below.

But the Scada connectivity is disabled.



So .. what am I doing wrong?

[felixst]

Good morning,

please make sure to active the checkbox "Symbol" of the variable properties.



Regards,
Felix

[leos]

Dear pauloodwazny,

Which zenon and bit version do you use here? zenon 8.10 in 64 bit?

In an early version of the setup a required DLL did not get installed in 64 bit:
C:\Program Files\COPA-DATA\zenon 8.10\IOD\K5zenonRT.dll

In such cases, it should work when starting the Editor and the Workbench in 32 bit.
For 64 bit, please obtain an actual zenon setup and do a new, clean installation of zenon 8.10.

It might also work to copy the file from a valid installation and then installing a newer build update to get all files of the present installation to the same version.
However, this has not been officially tested by COPA-DATA.

Best regards,
Leo

[pauloodwazny]

Thank you,
it was the file (K5zenonRT.dll) problem.

Dear pauloodwazny,

Which zenon and bit version do you use here? zenon 8.10 in 64 bit?

In an early version of the setup a required DLL did not get installed in 64 bit:
C:\Program Files\COPA-DATA\zenon 8.10\IOD\K5zenonRT.dll

In such cases, it should work when starting the Editor and the Workbench in 32 bit.
For 64 bit, please obtain an actual zenon setup and do a new, clean installation of zenon 8.10.

It might also work to copy the file from a valid installation and then installing a newer build update to get all files of the present installation to the same version.
However, this has not been officially tested by COPA-DATA.

Best regards,
Leo

[hamilpa]

Dear pauloodwazny,

Which zenon and bit version do you use here? zenon 8.10 in 64 bit?

In an early version of the setup a required DLL did not get installed in 64 bit:
C:\Program Files\COPA-DATA\zenon 8.10\IOD\K5zenonRT.dll

In such cases, it should work when starting the Editor and the Workbench in 32 bit.
For 64 bit, please obtain an actual zenon setup and do a new, clean installation of zenon 8.10.

It might also work to copy the file from a valid installation and then installing a newer build update to get all files of the present installation to the same version.
However, this has not been officially tested by COPA-DATA.

Best regards,
rufus

Such cases, it should work when starting the Editor and the Workbench in 32 bit.
For 64 bit, please obtain an actual zenon setup and do a new, clean installation of zenon 8.10.