3S_V3 driver to communicate to ABB500 PLC

[milosh]

Hi all.
I use zenon Operator 7.6 with driver 3S_V3 on Win7 OS Pro to communicate with ABB AC500 PLC.
Driver settings are attached.
When I tried to Import variables from driver error occured with message:
ERROR: Could not import symbols from net address [11]!

Ping with PLC works good. 
What can be the problem with communication?!

Thanks in advance
MK

[david.cerdeira]

Dear milosh,

the information given is too vague so that we can give you a qualified answer.

Is the PLC reachable via PING command?
Is the PLC handler version the same of the 3S_V3 driver? Kindly have a look on the documentation topic: Drivers -> 3S_V3 -> Requirements.
Did you check already the 3S_V3 driver logs in Diagnosis Viewer?

I strongly recommend you to contact your local Support Team for further guidance and assistance.

Best regards,
David Cerdeira

[eden212]

hi i'm adding a picture of the correct configuration that works for me and a manual to set the settings in codesys.

[smithclarkson001]

hi i'm adding a picture of the correct configuration that works for me and a manual to set the settings in codesy. https://9appsapk.vin/https://vidmateapp.vinhttps://vlc.vin

Thanks for help man....I was also facing similar difficulty in configuring....but now i could configure it correctly...!