DNP Configuration

[philipe0136]

Hi Guys, what's up?

I'm beginner on Zenon Energy software, I'm trying to communicate Zenon with Elipse Power with DNP3 driver.

In Elipse, I put the DNP Slave and correctly configurated the tags (A simple Digital Input and Analog Input).

In Zenon, I don't know how to configure correctly to be the master, anyone can help me?

[markclemens]

Hi Philipe,

Have a look at the COPA-DATA tutorial videos on youtube

Assuming you have already created a zenon project, here you can find general information on the zenon DNP3 master driver DNP3_TG and how to configure this driver.

Best regards,
Mark

[philipe0136]

Thanks for help, it's still doesn't working, I think because both programs still running in the same machine, perhaps have some IP conflict, I'll try to run elipse in a VM and I'll return with my results.

[markclemens]

Hi Philipe,

I don't know Elipse Power, but in many DNP3 outstations you need to configure both the IP address of the DNP3 master and the corresponding DNP address of the master.

For the IP address, on the same machine, it may work when you use 127.0.0.1. For the DNP address of the master, whatever address you use, be sure to also use this address in the source address of the DNP3_TG master driver configuration.

Best regards,
Mark

[philipe0136]

Hello Marck,

I did everything follow instructions by the link you sent here, but still doesn't work, i'll try to configure using different IPs to check.

I follow theses instructions to configure Elipse DNP Slave

 https://www.youtube.com/watch?v=IZpuCO4YNaM&t=344s 

[philipe0136]

Hello Marck,

I did everything follow instructions by the link you sent here, but still doesn't work, i'll try to configure using different IPs to check.

I follow theses instructions to configure Elipse DNP Slave

 https://www.youtube.com/watch?v=IZpuCO4YNaM&t=344s 

Using This link https://www.youtube.com/watch?v=IZpuCO4YNaM&t=344s

[philipe0136]

My log File sent by attachment

[philipe0136]

Wich Driver I choose for this? In DNP directory has only DNP3_TG, is this correct?

[markclemens]

Hi Philipe,

Thanks for sending the log file of the diagnosis server. It can be seen that you've attempted to perform an online import of variables in the editor. It appeDNP3ars the TCP connection could be established correctly, but when the DNP3_TG driver sends a read request for Object Group 60, variation 1,2,3,4 (Class 0, 1,2,3) there is no response.

This can happen if the master is not configured in the outstation or if the outstation address used in the DNP3_TG DNP3 master driver is different than the outstation address.

Best regards,
Mark

[philipe0136]

Thanks, Marck for help, I guess the driver is the problem, different software, different driver run into them, anyway, I'm grateful.