Showing results 1 to 2 of 2

Thread: how to share variable from external PLC to other PLCs in the network using Zenon SCADA

  1. #1

    Default how to share variable from external PLC to other PLCs in the network using Zenon SCADA

    I am reading wind data from Delta PLC using Modbus TCP/IP. I want to send this wind data to other PLC Slaves(Delta) in the network using Zenon SCADA. Is this possible without using Zenon Logic?

    Thanks
    Lingelethu Dyasana.


  2. #2
    Join Date
    10.12.2007
    Posts
    177

    Default AW: how to share variable from external PLC to other PLCs in the network using Zenon SCADA

    You only need an allocation. Choose Source an destination Variable - that's it.

Similar Threads

  1. Replies: 2
    Last Post: 27th August 2018, 10:08
  2. zenon logic doesn't communicate with external variables in zenon
    By mashjj in forum straton / zenon Logic
    Replies: 6
    Last Post: 27th February 2015, 13:10
  3. Re: zenon logic doesn't communicate with external variables in zenon
    By anjali.gk.nair@gmail.com in forum straton / zenon Logic
    Replies: 2
    Last Post: 22nd August 2014, 10:51
  4. Minimal external variable change interval to be hooked in zenOn
    By stolyarov_as in forum zenon Supervisor
    Replies: 1
    Last Post: 24th September 2013, 18:38
  5. Managing redundant PLCs
    By vasco in forum zenon Network
    Replies: 6
    Last Post: 19th April 2010, 13:58

Posting Rules

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •