Showing results 1 to 2 of 2

Thread: change "Value adjustment linear"

  1. #1
    Join Date
    03.01.2012
    Posts
    9

    Default change "Value adjustment linear"

    Hello!

    Tell me please. How chage "Value adjustment linear" from VBA?
    Need change "Measuring range max." and "Measuring range min." using other variables zenon.

    Thank you very much!

  2. #2

    Default Re: change "Value adjustment linear"

    Hi boykoo,

    What exactly are you trying to achieve? If you just need to display the values in e.g. in Volts / Kilovolts and be able to switch between these units, then you could have a look at the central unit switching.

    For non-linear value adjustment, try searching for "AdjustZenOnValue" and "AdjustHardwareValue"

    These are the macros that can be used for non-linear value adjustment, where you have the option to change the value adjustment based also on other values.


    Best regards,
    Mark

Similar Threads

  1. RGM - VBA - ".Save" / ".Read" - change recipe status
    By markclemens in forum zenon Service Engine Supervisor
    Replies: 12
    Last Post: 29th September 2014, 12:25
  2. non-linear value adjustment
    By sebastiank in forum VBA
    Replies: 1
    Last Post: 24th May 2013, 04:30
  3. Alarmmeldeliste Filter "nicht quittiert" ODER "anstehend"
    By scheweeric in forum zenon Service Engine Supervisor
    Replies: 3
    Last Post: 31st July 2012, 15:20
  4. Replies: 5
    Last Post: 28th November 2008, 10:49

Posting Rules

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •