Showing results 1 to 2 of 2

Thread: IEC61850 - Problem recieving goose

  1. #1
    Join Date
    03.11.2014
    Posts
    10

    Default IEC61850 - Problem recieving goose

    Hi!

    I am running a SCADA system on two computers on the same network. They are recieving goose messages from a raspberry pi running straton. However, 1 of them does no recieve the goose message even though the ZENON SCADA Workspace is identical. Do you have any advice on how to deal with this? I am asumming that network settings or firewall is limiting the goose reception on one of them.

    Best,
    Jonas

  2. #2
    Join Date
    01.07.2008
    Location
    Salzburg, AT
    Posts
    1,038

    Default Re: IEC61850 - Problem recieving goose

    or both publishers are using the same APPID so the subscriber cannot distinguish which data set should take to interpret received data.

    Make sure that your publishers have different APPID (numerical setting in SCL, in section communication).

Similar Threads

  1. Recieving Goose on Raspberry Pi (Straton)
    By jonastj in forum Engineering Studio Logic & Logic Service (former zenon Logic Workbench & Runtime)
    Replies: 3
    Last Post: 15th June 2015, 14:08
  2. Iec61850
    By hajjsaid99 in forum zenon Energy Edition
    Replies: 7
    Last Post: 28th January 2015, 12:03
  3. Problem in Trend for IEC61850 data
    By askrajput in forum Drivers
    Replies: 2
    Last Post: 19th May 2014, 08:55
  4. GOOSE messages in STRATON
    By mansoorhussain in forum Engineering Studio Logic & Logic Service (former zenon Logic Workbench & Runtime)
    Replies: 3
    Last Post: 14th January 2011, 00:37
  5. Iec61850 Error
    By hoscillada in forum zenon Energy Edition
    Replies: 9
    Last Post: 10th December 2009, 13:33

Posting Rules

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •