Showing results 1 to 4 of 4

Thread: Communication and CPU - Power Problems

  1. #1
    Join Date
    18.08.2011
    Posts
    6

    Böse Communication and CPU - Power Problems

    I did the Connection with WIFI from zenon RT to EV3.

    If i just use the variable monitor in zenon logic - it works (but also there, every 5 to 10 s there is an interuption of the communication between Controller and PC).

    When i start up zenon RT and communicate with some variables, it is a Desaster.

    I lost the Connection every second and the Controller is out of order - there is sometimes a delay of 20 to 30 s until the command is written to the Controller!

    Are there any Settings to Speed up the communication?

  2. #2
    hansvanzijp Gast

    Default Re: Communication and CPU - Power Problems

    Hello Marcel,

    First be sure to have the latest runtime version on the EV3.
    I think V1.3/8.2.101109 is the most recent. The 20-30 seconds probably come from the reconnect delay in the zenon driver settings. You can make that shorter if you want.
    Also reduce the cycle time for the zenon logic project, so there is enough time left for the communication.

    Kind Regards,

    Hans.

  3. #3
    Join Date
    18.08.2011
    Posts
    6

    Default Re: Communication and CPU - Power Problems

    Hi Hans

    i used the Version you mention.

    Cycle time --> you mean to extend the cycle time, not to reduce (i am already at 600ms - with this you never get a proper control for Motion!).

    The 20 - 30 seconds is not for reconnect - this Setting is by 1s, it's the delay between a command and the reaction of the Controller!

    I reduce my application now and make more sequentially - i hope this would help ...

  4. #4
    hansvanzijp Gast

    Default Re: Communication and CPU - Power Problems

    Hello Marcel,

    I am running at 50 msec with a small program and that's not bad.
    I do see a red dot every now and then, but it is much better as before.

    Succes,

    Hans.

Similar Threads

  1. Absturz durch CPU-Überlast
    By schroder in forum zenon Supervisor
    Replies: 1
    Last Post: 8th July 2013, 07:58
  2. Load on CPU
    By shikra in forum zenon Supervisor
    Replies: 2
    Last Post: 8th October 2011, 09:27
  3. S7-200 CPU with IBHLink++
    By fblanco in forum Drivers
    Replies: 5
    Last Post: 1st July 2010, 21:02
  4. Prot. Relay-Power supply failure monitoring
    By janlyndon in forum zenon Supervisor
    Replies: 10
    Last Post: 18th May 2010, 22:57
  5. Client - Server communication problems
    By dragosmoss in forum zenon Network
    Replies: 8
    Last Post: 13th May 2009, 14:38

Posting Rules

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •