Showing results 1 to 2 of 2

Thread: Total number of alarm in alarm area, class or group

  1. #1

    Default Total number of alarm in alarm area, class or group

    Hi,

    Need to clarify is it possible for me to shows the number of active alarm within a alarm class, area or group. for example two variable is linked into same area. then, when both alarm is triggered, then number will changed into 2. when one of the alarm is acknowledge, the the value is reduce to 1.

    Thanks

  2. #2
    Join Date
    01.07.2008
    Location
    Salzburg, AT
    Posts
    1,107

    Default Re: Total number of alarm in alarm area, class or group

    this is exactly what alarm aggregation in Areas does. Link the additional (internal) variables to the area and/or to linked classes (sub-nodes you can create in each area). 

Similar Threads

  1. Group alarm characteristic
    By zeynal.sabas in forum zenon Energy Edition
    Replies: 0
    Last Post: 5th June 2018, 10:06
  2. How can I tell if there is an active alarm in an alarm group?
    By mjackson in forum Engineering Studio & Service Engine (former zenon Editor & Runtime)
    Replies: 4
    Last Post: 21st April 2017, 14:17
  3. Replies: 5
    Last Post: 8th October 2014, 13:47
  4. Set variable alarm group
    By davide.galigani in forum VBA
    Replies: 4
    Last Post: 11th June 2014, 19:42
  5. Alarm area inside another alarm area
    By davide.galigani in forum Engineering Studio & Service Engine (former zenon Editor & Runtime)
    Replies: 5
    Last Post: 10th May 2012, 08:16

Posting Rules

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •