Driver Simulation Wizard

[aizatmasuri]

Hi everyone,

I am trying to create a IEC104 driver simulation using driver simulation wizard. After following the manual, I have close the logic workbench. I have also enable the variable that i have created externally. Somehow, there is no code is written at my sim_program ST. I want to ask, what is the proper procedure to use the driver simulation wizard.

Many thanks 

[ursulak]

By me it works perfectly. It is hard to guess what was wrong in your project, i do not even know the zenon version you are using, neither variable names etc. 
Maybe contact the Support officially and send the project backup.